Geometry Hookah Ronin 3.0

Geometry Hookah
699,00
RONIN 3.0

It consists of two main components: a metal flask with main shafts and a wooden supboard made of solid walnut.

The metal flask can exist as a separate and independent hookah.

There are 2 shafts installed vertically at the base of the hookah - the main and submersible.

There is a risk to determine the water level inside the flask. By playing with the water level, you can adjust the draft density. But it is worth noting that the draft of the Ronin hookah is special, inherent only to this model. It cannot be compared with any other classic-type hookah. The draft level is average, closer to the classic, non-diffuser.

The metal flask itself is screwed into the base on a thread. This makes it easy to care for the hookah.

The purge valves are located at the top of the hookah. There are only 3 of them, the diameter is 8 mm.

Surboard. The flask is attached to the sarboard using a magnetic connector. In this case, the smoke passes additionally through a horizontal shaft in the SUP board.

The SUP board is collapsible, which allows for convenient maintenance of the hookah after use.
The wooden parts are put on the metal skeleton of the SUP board.

The "metal tray" is designed for ash and coals.
On the opposite side there is a stand for a smartphone.

Weight: 6,000 g.

Materials - stainless steel, solid walnut wood;
Inner diameter of the shaft is 11 mm;
Parameters for the molasses catcher - thread M14, thread pitch 1.5;
Magnetic hose connection.